Category: westfield

DSC_8404 0

Brake Light

The Westfield is so low that being seen by other drivers is going to be a big challenge. Because of this, I knew that I wanted a really bright 3rd brake light that was...

DSC_8394-2 0

Shifter

I needed to do some work on the shifter because of this rip in the boot: When I had it apart, I found this: That little white bushing in the slot should be symmetric....

exhaust_thumbnail 0

Engine In

We got the engine in this weekend: It went pretty smoothly and everything lined up nicely, even the scary hole in the side of the bodywork where the exhaust exits: Here are some action...

off_stands_thumbnail 0

Get Down

Three garage days in a row was exactly what the doctor ordered. I got a lot done on the car this weekend. I started out by building a new bracket for the fuel pump....

body_rear_thumb 0

Fitting Rear

I got the rear end of the body attached this weekend. This involved drilling a few scary holes, but they all turned out pretty well.

bodywork1 0

Fitting Bodywork

This was a busy weekend in the garage. I’m starting to install the body on the Westfield. That involves a lot of fiddling around to get all of the joints to come out nice...

bracket 0

Fusebox Bracket

I now feel like I’ve been working on the front wiring harness forever. But I did accomplish something today. Part of the wiring is mounting all of the fuseboxes, relays, and other electrical bits...

wirecull 0

Wiring

I’ve been spending a lot of time on the wiring harness recently. A lot of the time is tracing wires I don’t need, like the door switches or radio, and removing them. This simplifies...

body_test_fit 0

Fettling the Scuttle

The next big piece of work on the Westfield is the wiring harness. Since that will need to go up under (and through) the scuttle, I’ve been working on making that fit. There’s a...

clutch2 1

Happy Meal

I finished up the back end of the engine today. That included replacing the O-ring on the crank angle sensor, which had been leaking, the cool new, lightweight flywheel, … and a new clutch....